Pantum P2500W Bedienungsanleitung PDF herunterladen (Seite 33)

4-2

4. Wired Network Settings (For wired network printer

models)

You may need to set some network parameters on the printer. These parameters can be set

from the embedded Web server.

4.1. Set IP Address

The IP address of the printer may be automatically obtained through DHCP function or set

manually.

| Automatic Setting

DHCP automatic setting function is enabled by default on the printer.

1. Connect the printer to the network through a network cable and complete the startup

preparation work.

2. The printer will automatically obtain the IP address assigned by the server. The IP address

obtained automatically can be used after a few minutes.

| Manual Setting

Type the IP address in the Web browser's address bar to open the embedded Web server.

1. Click Settings in the navigation bar to open the Settings page;

2. Select Network Settings - IPV4 Settings;

3. Set IP Address Assignment Mode (Manual), IP Address and Subnet Mask. Other items are

optional;

4. Click Apply to save the settings.

Note: • If DHCP cannot automatically obtain the IP address, the printer will automatically

use the default IP address: 169.254.xx.xx.

• Due to the features of DHCP, the IP address of the printer automatically assigned

by the network may vary if the printer has not been used for a long time or the

network access point changes, which could result in unsuccessful connection to

the printer. It is recommended that the IP address automatically assigned by the

network is bound to the MAC address of the printer while the DHCP function is

enabled.

Note: • You can use the embedded Web server to change the IP Address Assignment

Mode into Automatic or Manual.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 77 78

Keine Kommentare

Pantum P2500W Bedienungsanleitung Seite 33